1998 Chevrolet Suburban 1500 Problems
RepairPal has identified the most common problems with the 1998 Chevrolet Suburban 1500 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The power door lock actuators may become slow to operate or stop working completely and require replacement.
The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault. The warranty has been extended on some of these units to 7 years or 70,000 miles.
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
The inside and outside door handles are prone to breaking.
The front or rear differential may develop an abnormal noise due to worn bearings or another internal fault. Our technicians tell us that a complete overhaul of the affected differential is commonly necessary to correct this condition.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The intake manifold gasket may develop an external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.
The steering may develop a clunk type noise from the upper intermediate steering shaft. Our technicians tell us that you should check with you local GM dealer to find out what the latest repair is for this condition.
The 1998-2001 Suburban 1500 has a known issue with the air pump check valve which causes illumination of the check engine light. There are no notable symptoms, but the vehicle will not pass state inspection or smog testing.
When the valve fails, it sticks closed, and the computer sets the code P1416. Replacement of the check valve is the only fix, as the valve is not serviceable.
The transmission may develop a harsh 1-2 shift and/or illumination of the Check Engine Light with code P1870 stored. This can be caused by wear of the bore for the TCC isolator and regulator valves in the valve body. This condition does not commonly occur until the transmission reaches normal operating temperature. If the valve body is worn, replacement will be necessary to correct this concern.
The headlight switch used on the Chevrolet Suburban 1500 is known to fail through normal operation. Since the headlight switch is also integrated into the interior lights, a malfunctioning switch can cause issues with interior lights as well.
- Symptoms of a failed headlight switch include:
- Headlights and taillights failing to turn on or off
- Interior lights flicker, or fail to turn on or off
- Gauge cluster lighting off or flickering with headlights on
- Parking light malfunctions
This issue is well known with General Motors Trucks and SUVs, and is solved by testing and, if needed, replacing the headlight/dimmer switch. Bad grounding wires at the tail-lights, and dirty/corroded tow package wires can also lead to some of these issues.
One or more fuel injectors may become stuck closed causing an engine misfire and the Check Engine Light to illuminate. Our technicians tell us that this problem can be caused by some fuel additives. There are special procedures which may be able to restore the affected injector. If this fails the affected injector must be replaced.