The Check Engine Light may illuminate, the engine may run rough and have misfires on acceleration. Commonly the ignition coils and/or the ignition coil boots are the cause of this problem. The rubber boot that insulates the coil to the spark plug can dry and crack allowing arcing. Inspect the coils and boots, and replace them as needed. Our technicians also recommend replacing the coil boots any time the spark plugs are replaced.
Resources for the Repair and Maintenance of your 2007 Ford E-350
2007 Ford E-350
2007 Ford E-350 Problems
The spark plugs may become dislodged from the cylinder heads. A loud popping noise can be heard and a subsequent misfire experienced. The threads on the spark plug ports in the cylinder head(s) can become stripped or missing when the spark plug is dislodged. The threads in cylinder heads may be replaced using “Lock-N-Stitch” aluminum inserts. Our technicians tell us thread replacement is performed when the vehicle is out of...
The front end may make a rattle noise over bumps. There may be handling issues, and play in the front wheels on inspection. If there is up and down movement on the front wheels while the lower control arms are being supported, inspect the upper and lower ball joints for excessive play. These are prone to failure from moisture entry and lack of lubrication. The ball joints should be replaced as needed.
Electrolysis can cause repeated failures of the heater core and radiator. The diagnosing technician should check for voltage present in the coolant, with the battery disconnected, because electrical current in the coolant causes electrolysis. Corroded or deteriorated parts should be replaced, and the coolant should be flushed. Ground straps can be added to help prevent future corrosion of components.
Engine oil may leak externally from the cylinder head gasket. The gaskets were contaminated with metal debris from the factory – between the block and gasket and/or the head and gasket. To correct, the head gasket must be replaced and the mating surfaces on the cylinder head and block need to be inspected for chips or damage. In some cases the cylinder head will not be repairable and will need replacement.
2007 Ford E-350 Recalls (Recent)
RepairPal Expert Overview:
An internal fault may develop within the multi-function turn signal switch. This can affect turn signal, tail, hazard, and/or brake light operation. Non-functioning exterior lights could increase the risk of a crash. Dealers will replace the multi-function switch to correct this concern. This recall is scheduled to begin on August 15, 2011. The Ford recall number is 11C18.
RepairPal Expert Overview:
Vehicles equipped with the 5.4L V8 may leak from weak areas in the fuel rail crossover hose. A fuel leak in the presence of an ignition source may start a fire. Dealers will replace the fuel rail assembly. The recall began March 3, 2008. The Ford recall number is 08S02.
2007 Ford E-350 Questions and Answers
I have a company truck that starts fine in the morning, considering it takes a few more cranks than what should be normal. it will run just fine once it does start, but as soon as i shut it off it ...
When i try to fuel up, I can only put a small amount in at a time because the pump keeps kicking off, like the tank is already full. It takes forever to fill the tank.
how to replace a hydractic clutch slave cylinder