1991 Toyota MR2 Questions
Get answers to questions about your 1991 Toyota MR2 at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
When I accelerate it stays on, but also jilts when going to 2nd and 3rd.
not sure what it could be I have replaced the throttle position sensor, EGR vacuum solenoid, plugs and wires, transmission shift solenoids, distributor cap and rotor button, coil pack ,flushed and clean engine and tranny inside and out , and still having the same problem . the car starts and runs great but when put in gear stalls out will drive in L, and once little past 20 miles per hour able to put it in D and it will drive but has hardly any power.
Anyone know what it could possibly be?
if hold throttle to stop it stalling when warmed up its perfect
I just perched a new Mr2 i put a jdm ECU in but didn't start so i put the original ECU back and it started up but then it died when i gave a little burst of gas. so i checked the alternator and it was bad. I replaced it and started her up went around the block and it died at the first stop sign. can any one help!?
I hope you and your wife are well and happy.
Car wasnt used for 2 months, when returned battery was dead, replaced battery, power windows, radio, ac/heater fan, tachometer all do not work. Battery light is on as well as Airbag warning light. Car runs fine but battery does not charge. Please assist
Key broke and lost, so have no key to turn the cylinder. Wish to remove the lock cylinder to have new key made at dealer or locksmith. Do not wish to destroy the lock if possible. I am a mechanic and know that there must be some way to remove the cylinder from the sleeve. Any help is appreciated. Am willing to pay for information. New cylinder is over 100.00 dollars. This is a car being restored. Thanks
location of back up light switch how hard is the switch
to put on
I heard a screeching sound and saw a plume of smoke from the engine compartment. I smell burnt rubber but engine now runs fine except the A/C quit working. Is it ok to drive the car with A/C off til I get to a repair facility?
i am atempting to reassemble eng and cannot obtain the proper info on torque to yeald head bolts. 1987 1600 4cyl, new hd gasket and new bolts, need guidance. thank you.
How much will it cost to repair a missing window in the rear passenger window? It's small in size but it had a keyhole placed in it that spider cracked to nothing.
WHEN I START MY MR2 THE IGNITION LIGHTS GO OUT INCLUDING THE RED OIL LIGHT SYMBOL AFTER A FEW SECONDS A ORANGE OIL LIGHT SYMBOL COMES ON THE HANDBOOK SAYS TO CHECK OIL LEVEL OIL LEVEL IS OK AS ARE ALL FLUIDS
When I start the engine, it has very little power. I push on the pedal all the way to the floorboard it I barely get enough power. I've checked the spark plugs,rotor,and rotor cap and they all seem to be fine. could you please help me diagnose the problem?
My dashboard on my toyota MR2 has cracked really bad and I would like to take it out so that I can repair it, But I'm not sure how to remove it. Can you help? Thanks.