Close

2005 Toyota Corolla Questions

Get answers to questions about your 2005 Toyota Corolla at RepairPal. Find solutions, diagnose problems and get back on the road.

Refine by vehicle
×
Choose your vehicle
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
136
questions

engine 1.8 gcc model poor pickup and when giving sudden accelarator engine light appear and disapper and not getting rpm more than 2000. But slow accelaration geting engine rpm up to 5000 . Maf sensor replaced new one .no any. dtc storing in ecu. Please give me good advise.

Erase the code

I need to know how to put back the pin that's comes from the centre dash door

No pattern discerned, but will sometimes start after several tries. Ruled out key and battery problems. Has been happening for about 2 weeks & problem seems to be increasing in frequency and severity. Security system unused but do need to engage engine protection system with key turn to start.

P0401 and P1604 what means?
how to repairs

Can I travel 600km now?

Iv put in water and can I travel more than 600km now?

it idols ruff and the brakes are hard to press like there is no brakes why is it doing this?

I have had new tires, keep oil changed, brake job, rotated,new belts

Air/Heat will blow out of the top vents(defrost) and middle vents, but air will not blow out of the floor vents. The cables are connected from the control knob to the side of something located on the wall between the engine and inside of the car and they move when the knob is turned. (sorry I am new to this site and didn't put what kind of car it was and couldn't figure out how to add that info.)

Air/Heat will blow out of the top vents(defrost) and middle vents, but air will not blow out of the floor vents. The cables are connected from the control knob to the side of something located on the wall between the engine and inside of the car and they move when the knob is turned.

All motor/transmission mounts are new and correctly installed. PCV valve new. New Iridium plugs. Clean throttle body and intake tubing, new air filter and oil change. Transmission fluid replaced with castrol import. Belt Tensioner and serpentine belt is new. Please let me know opinions. Vibration can be felt through fenders, floor, and steering wheel. Have checked exhaust system. No check engine light. Engine vibrate violently, but idle is proper at about 750-800 rpms when warm.

This happens when there is snow/rain. The only way to get them to stop is turning off the car as they go non-stop while driving.

I have tried jumper cables and have checked all fuses in the engine area to include the ones behind the steering wheel. Everything works except the car will not do anything when the key is turned.

Had these codes. P0123 TPS A circuit high input P2103 Throttle actuator control circuit high, P3125 TPS A/B Voltage correlation