Close

1997 Oldsmobile Silhouette Questions

Get answers to questions about your 1997 Oldsmobile Silhouette at RepairPal. Find solutions, diagnose problems and get back on the road.

Refine by vehicle
×
Choose your vehicle
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
21
questions

wont shift past 2gear just revs up from there put in 3 gear same thing put in overdrive same thing

Or where is the fuse for it located?

Blowing cold air, will not warm up

almost wants to start but doesn't what's the problem

thermo signal runs high after 5-10 mins then goes to zero. new thermostat placed last year. Blows cold air still after 1/2 hr(unless on highway),fans dont blow well except rear blowers

Just before it quit it would work and then not work. It would work on and off for about a month before it quit completely. Also occassionaly my left turn signal will blink fast as if there is a bulb burned out somewhere but there isn't. It goes back to working properly after I turn it off for about 2 minutes.

I have checked the cost of the part, and it is around $30.00. Wondering how labor intensive is it to fix. Also, it an intermittent problem, doesn't happen every time shifting from first to second, and doesn't happen at all once I get over 25 mph, if I do not repair immediately, will it cause additional problems or a breakdown?

I have checked the cost of the part, and it is around $30.00. Wondering how labor intensive is it to fix. Also, it an intermittent problem, doesn't happen every time shifting from first to second, and doesn't happen at all once I get over 25 mph, if I do not repair immediately, will it cause additional problems or a breakdown?

Says it needs 2 lbs in front and 2 lbs in rear....where do I add to rear?

continous car stalls out while driving but will start right back up

1997 Silhouette passenger automatic sliding door made knocking noises after closing. After several times of doing this it quit working altogether. Checked fuses. Would like to know where to find the door motor and where the cables are. That is what it sounds like to me.

was to motor not getting oil to it.can it be fixed or do i have to buy a new motor?