When driving for a while, the car loses power and starts "hopping" I cant get the rpms up past 3 and it just has no power? We gave it a tune up and replaced the distributor cap, wires, plugs etc....thought it fixed the problem, but on the way to get emissions, it started doing it again! Does anyone know what could be the problem?

Will go into 2,4,rev. If jammed

I replaced clutch cable on my 97 200sx ser and now the pedal stays on the floor after I press it in. Adjusted the cable to correct ratio as well. What woulld the main issue be?

wont start regardless of what I do, it has new purge valve, new iac valve, new battery, still nothing.

Don't work on 1,2,3 only on ,4 the highest

My timeing chaine broke while I was driven and I drove it a couple miles with it being broke can it be fixed

There's a clicking noise coming from behind the dash on the drivers side. It's a standard but it won't even roll start. Drove it to destination but when I went to leave was when it wouldn't start and the clicking started.

My car usually stalls out while turing up or down hill.

I've replaced the sensor,had it reset & the check engine light came back on & the obm still stays there's a speed sensor malf. I was told that the cruise control had stopped working while in use one day and thats when the check engine light originally came on and has been a problem every since. Could the cruise control which does'nt work at all be cuasing my problem? If so, what should i do?

The car won't turn on unless I put power from the battery to the starter solenoid.

I have a 97 Nissan 200SX and the windshield wipers don't work. I took it to someone, and they tried putting in a new motor, and it still didn't work. He said that the wires have been cut and put back together, melted together and all kinds of stuff. I have no idea what to do, and I need a second, third, or as many opinions as I can get. Where should I take it to get fixed and how much will it cost me? Please help!!!!!

how do i replace the rubber boot on the outboard cv joint