Nissan 200SX Questions
All Nissan 200SX Questions
Ask a Question
I replaced clutch cable on my 97 200sx ser and now the pedal stays on the floor after I press it in. Adjusted the cable to correct ratio as well. What woulld the main issue be?
It stalled on me last night. I got it started but I had to keep the rpms up so it wouldn't stall. Something gunned up
I read that voltage to CKPS should be 5 volts but I only measure 9.5 mV. Resistance in CKPS measured 485 ohms. Is problem in ECM? Or should I look else where?
I changed the bulbs, the problem is still there. Is there a relay or something that could be possible bad, or is it the switch on the steering column?. How to fix the problem???
Looking at junk yards for a front bumper cover and grill (2 separate parts)- Is there any other model that will work? Looks like this year is not compatible. Help!
wont start regardless of what I do, it has new purge valve, new iac valve, new battery, still nothing.
My OBD 2 reads pending after 240 miles to re-activate sensors all are ok. Cat still reads pending. Can my oxygen sensor be passing but are almost gone or dirty? There are no diagnostic code or engine light.
Pulled radio and got to plastic thingy and all parts work but wont switch between defrost and any other setting cant get to where cable attaches to flap(?) that changes it from defrost to floor etc.
I just bought my car, used of course. I took it to AutoZone to get a diagnostic and they told me my speed sensor needs to be replaced also my knock sensor and Oxygen sensor. I want to replace them by myself ive been l...
I tried everything to get them off and had to take the hot post off the battery and leave it off to get the brake lights off do you know what this could be??
I cant seem to have both on .
If my air conditioning is on car will not start. So I turn off ac and then the car will start.. why???
Don't work on 1,2,3 only on ,4 the highest
we replaced the motor the check engine light came on when the other motor blew up and the light has never gone out
Son said it ran great all day, 101 degrees out, then as he went to put it in park, it shut off, then wouldn't turn over, starter noises like a small grinding shriek, then 10 minutes later started right up and he drov...
My timeing chaine broke while I was driven and I drove it a couple miles with it being broke can it be fixed
There's a clicking noise coming from behind the dash on the drivers side. It's a standard but it won't even roll start. Drove it to destination but when I went to leave was when it wouldn't start and the clicking star...
The car has been a great car, but now will not start. The dash lights come on, windows & radio work. But when I lock the car and try to open the door with the window down, the security alarm does not sound. Does thi...
She died the other night, I've changed the distributor cap & rotor. Its not the battery, and does not seem to be a starter or alternator. Anyone know much about the timing on this car? i know the chain is old but as f...
My car usually stalls out while turing up or down hill.
I've replaced the sensor,had it reset & the check engine light came back on & the obm still stays there's a speed sensor malf. I was told that the cruise control had stopped working while in use one day and thats when...
had to take the belt off to replace my drive belt and can't get it back on
have a 1998 Nissan 200SX it has been sitting for just under 2 years, We have decided to use it again. We were told that since there was less than an eighth of a tank of gas it should be ok to put a gas treatment in t...
MY CAR OVER HEATED AND WILL NOT RESTART. I HAVE LET IT COOL OFF OVER NIGHT AND IT WILL NOT START
location of expansion plugs (freeze plugs)on my 1996 nissan 200sx
I have owned this car for 4 years, and it has been a nice reliable vehicle. Until recently the cars rpms have been fluctuating up and down, sometimes up to 2200 rpms, and sometimes so low that it stalls, why??
we have cecked the starter alt. and battery.on the fuse box under the hood on the passager side clicks .you can feel the clucth fuse when you try to start it