2006 Mazda MAZDASPEED6 QuestionsRefine by vehicle
Car died and required a jump start
Codes are; (u0121) abs control module
(U0155) Cluster (IPC) control module
(U 0101) TCM Communication & ECM/ PCM(U 0100)
(P2111) Throttle actuator Control system stuck open
(P2110) Throttle actuator Control system Force limited (RPM)
ABS Pump Motor Relay/Pump Motor Circuit Malfunction needs to be addressed ABS and TCS lighrs are on solid on the dash display. Sounds like an electrical problem but not sure where to start???
AWD--front and back tires different in size. drove for 6 months until the smaller tires on the back were ripped to shreds along with a grindy, knocking noise coming from all the wheel areas. after putting the same size tires on, just a knocking noise by the wheels and big loss of power
Ok i got timing chain replaced at Hall Mazda in virginia beach. Once i got it back about a week goes by and then im crozin along and i hear a knocking. took it back to them and they said it was unrelated to there work. But they said the knocking was coming from oil pan. Could this be a bad Crank bearing? They said the thrust bearing was still good. But how much would it cost to get the crank bearings replaced?