Close

1993 Mazda B2200 Questions

Get answers to questions about your 1993 Mazda B2200 at RepairPal. Find solutions, diagnose problems and get back on the road.

Refine by vehicle
×
Choose your vehicle
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
9
questions

Will a windshield from a '92 B2200 fit on a '93 B2200?

Low beam only one side work, HI beam two sides work

What is the problem. Thank you

I have a Mazda B2600 2.6L 5 speed manual transmission. Why does is keep burning out the mass flow sensor? What can I do to remedy this problem?

My cooling system has to much pressure. I changed head gasket and intake manifold gasket and it still has the same problem. It ran good for about four hours and the old problem came back. Now it smokes, misses and has to much water pressure. All my hard work and new parts didn't fix a thing. The old gasket's were fine before I damaged them taking things apart.

Having to change oil pan gasket which is the easiest way I was told drop sway bar than told not to. have to lift motor up 2 inches

Issue occurs in 1st and 2nd gear, where the grabbing or stuttering action happens upon releasing clutch. Have had slave cylinder replaced approximately 2 years ago; cracked manifold replaced 1 year ago. 135,000 mi. 2.2L, not FI. Clutch fluid level checked 1/mo., full.

The engine smokes probably a blown head gasket so how much does an engine overhaul cost?

My heater always has a bit of heat coming from it. Even in 75 degree weather I have to run the air conditioner to keep the cab cool. Is there an adjustment that can be made with the dial? Is there some other kind of problem to deal with?