1993 GMC Yukon QuestionsRefine by vehicle
writing from Italy . typhoon 1993 .electrical problems after replacement of engine of my typhoon in 1993: before dismounting it was all right, now the water temperature indicator rises slightly and comes light on the engine problems after a few seconds. We changed all temperature sensors, thermostat, but nothing changes. the engine ,cold or hot goes in motion, but cold if you switch it off after 1 minute, switching on again if seems flooded. tester says that water temperature is very low. we no longer know what to do. Thanks if you can help me
Map . collant sensor. Tbs
was told torque converter not locking up and causing transmission to overheat which is burning up transmissions in a matter of a few weeks.
Runs well when i first drive and after driving it for over 30 minutes or so when i come to a complete stop it shuts down. Also after the truck has been running for over an hour and i turn the truck off it will not start back up untill it cools off. Any ideas of what it could be ?
it started with my distribuator,so i would just turn it but know it turns on and off
How do I clean the throttle body?
it starts with about 30-40# pressure and drops down to about 20 when the engine is warm, even at freeway speeds. time for a new pump? the sender is new!
i have a 1993 gmc yukon when i start it in the mornings the check engine light comes on and it runs really rough but it runs and when i stop to get coffee and cme back out its fine can anybody tell me what this is all about please and i changed my brake hoses in the front and ever since then my park brake light is on and my abs light is on i have bleed my brakes and they work fine can any body tell me about this how to get them to shut off
Will a 1993 GMC Yukon motor fit in a 1998 Chevy tahoe?
stability / brake system indicator light and bell
I need to know the level of fluid to replace after the fluid has been drained in the rear differential. How much do I put back in?
remove freeze plugs
I have a 1993 GMC Yukon. The rear hatch (upper window) will not open. The relay kicks on like it is unlatching, but when the switch is released the latch sounds like it is closing again. Where is the motor located for the latching mecanisim? Also is there a possibility that it is in the switch or one of the relays?