24
questions

Car won't stay running. I need video to change spark plug wires

Replacing lower ball joint.. Need step by step instructions

everything was working for 10 min, then the radio quit. the car was idling as i was looking for a solution, then the interior lights and radio came on for a few seconds then went off again.

I replaced the combo switch on the steering column. Every other feature that the combo switch operates, works fine. Washers pump, turn signals work, hazards come on, and headlights switch between hi/lo as well. Wipers will not come on, though. Any ideas on what it could be or how to fix it?

Roy, I apologize for my son's response. I didn't know it was sent until now. Rest assured he won't even have access to this again. Someone told me the grommet only came the way i got it. one piece. 3 pieces does sound ten times easier. i'll definately swap it out for the other one. Shoot, that grommet will out last the car. Can I get back to you if I have any other problems? thanks for your help

I'm replacing the grommet in the inner, left side tie-rod. It's missing right now and assume it has been for a while since it shakes like crazy and goes through tires like theres no tomorrow. Anyway like i said i know the basics...how it works etc. Through experience, i know there's always little pieces of information(tricks)that can make the difference of 3 hrs or 3 days.........Do i take the tie rod out to replace the grommet or replace it with the outter still connected? Easiest way to get the grommet in the eye of the rod? Q&A like the ones above. Thanks

how do I replace the egr valve and where is it located





















The wipers motor had like a belt it busted so do can







can the belt be replaced and where can I buy











just need driver side head gasket replaced

MY CAR KEEPS STARTING HARD .. WILL START WITH STARTING FLUID ..BUT NEEDS IT ALL THE TIME , WILL STALL ON ME RIGHT IN THE MIDDLE OF A TURN ..FUEL PUMP?? YA THINK?? THANK YOU SO MUCH

how much to fix motor mounts

need to hot wire the system to get heat now