40
questions

instructions or a video would be great.

seen oil on axle ,none in diff when axle can move around it must need bearing and seal ?Or maybe a used transaxle with no slop and has oil would be best?

Replaced bulb, but still very dim

URGENT, I am stuck at a friends house.

Vehicle drives fine shifts fine until 45 MPH then it seems not to want to shift into over drive, my question, is here shift solenoids in this transmission i have done research and it shows i have M41 trany or 03-72LE, where can i find more info on this transmission?

I own a 200 chevy tracker for some reason the key will not turn and the steering is locked. But the automatic shifter will pull out of park So frustrated

The ignition key will not turn steering is locked but will shift to neutral. The ignition was fine when parked steering fine. Since engine has been put back in we cannot move it or start it. Please help

My car recently was overheating when you drove it for more than 2 minutes. My dad changed everything he could think of in the front of it, including : thermostat, radiator, fan, belts, water pump, & fuses. It quit overheating but will not keep the battery charged. You can drive it until it runs out of battery then someone must jump it to get home. We went out and bought a new alternator and 2 new batteries and still having the same issue it will not charge. We had the old and new parts tested and all passed. Can anyone help me figure out what else could cause the battery not to charge?

when i drive it for a while it tries to bog down, i press the gas a couple times and its fine. Check engine light comes on it says mass air flow sensor its been clean, acted fine for about a day but not its back to the same problem.

When i put the tracker in drive it has no power, it will pull out but when you give it more gas it does not respond. It has plenty of power in low and reverse. I am showing codes PO758 and PO743. I have changed the shift selenoids and it has not helped. At one time it was showing shift selenoids A&B.The tracker has been wrecked and I had to replace some of the wires in the front of the radiator support. Any help would be appreciated