1993 Chevrolet Camaro QuestionsRefine by vehicle
no security light on battery fine started working all fuse working can't figure it out please help
Clutch this pressure plate throw out bearing pilot bearing have all been replaced hydraulic system has been bled car goes into gear when engine is off just grinds when it's on
can the module be causing this
My camaro idles right until you put it in gear then the rpms go to 1500.Ihave replaced the IAC but it still does the same thing,it is a throttle body, what could cause this?
It idles normal until you put it in gear then the rpm,s rises to 1500,I recently replaced the IAC then a while later it started doing this.It is a throttle body,What could cause this.
Just bought this car and it needs coolant if you can help me out it will be truly appreciated thanks!
be cautious, no sharp turns, no excessive speed and definetly no road trips. I have been told it's the ball joint. If it is the ball joint and I continue to drive it for a month or two, what will happen?
Could this something besides the bushing/bearing
The pressure builds up and it runs hot. Have put on a new water pump and thermostat.
occasional rough idle/drivability. most noticable during acceleration and increases when turning on fog or head lamps. dealer speculated fuel injectors.
would it be fuel injectors if condition worsens with additional draw on electrical system?
I have a 92 or 93 monte carlo. I couldn't find monte carlo, so put camaro instead. my security light is blinking and the car won't start. I had the steering wheel changed.I don't know what the code is because I bought the car from a sale. What can I try in order to get my key work with the code that has been set for this car?
my wipers want retract all the way down it has just started doing this and i cant figure it out please some one help before i go insane
replced optispark last summer and car ran fine it has since started to stall out intermittantly changed coil fuelpump relay and coil module still spark quits as soon as you apply the throttle help!!!