Verify procedure before replacing starter on Jeep Comanche

Be sure to verify starter replacement procedure before replacing the starter. A new starter replaced the older design and does not use a shim in the installation. Incorrect use of the shim can cause starter noise or may damage the starter.

RepairPal Verified
Average mileage: (–)
3 model years affected: 1990, 1991, 1992
3 people reported this problem
0 people shared problem details
Related Items:
Can the fuel pump assembly be removed from the tank without removing the tank?
The throttle position sensor (TPS) may fail causing intermittent drivability problems like...
I have a 1988 Jeep Comanche that keeps blowing out slave cylinders. Just replace the slave and...
Some models are susceptible to rear main oil seal failures in dirty or dusty conditions. As dir...
What would be some of the causes for water in the oil? Motor was recently rebuilt but sat up f...

Related Content