2005 Toyota Matrix QuestionsRefine by vehicle
i have a fairly new Battery, radio,power windows work , but i turn the key to start the car and nothing happens ,Does not even turn the engine over.
has anyone had this issue? car only has approx 67000 miles on it.
the repair shop quoted me $795 to replace both axels and boots and they are planning to use after market parts. is this price fair and are after market parts safe to use? i'm planning to keep the car as long as possible, will the axels and boots need to be replaced again in another 67,000 miles? thanks for any input.
hi I have a 05 matrix with a a/c electrical problem everything starter with the a/c compressor not getting good ground and then now I have no power on the main a/c relay, my question is if the car has another fuse inside for the a/c system? my switch inside the light wont turn on I just have the fan blowing. anybody here has a idea what could it be.
The SRS indicator light goes out in 5 sec 95% of engine start-up. If it does not go out an engine restart usually will cause the light symbol to go out. I have noted the light has not function properly since we have reached over 100* heat days. What avenue should I take with this problem and what repair options will I be subject to encounter. Thank you.
I had my car checked at the garage they said the breaks were fine and They lubricated the callipers but the sound has now come back after a few weeks since doing this.
The sound happens when I am braking only
WHEN I TAPE THE GAS PEDLE UNTIL PUT THE CAR IN GEAR. ALSO WHEN THE ENGIN IS WARM AND REMOVE MY FOOT FROM THE GAS IT DOES NOT WANT SLOW DOWH. BUT ONCE I APPLY THE BRAKES IT WILL DROP THE RPMS DOWN TO 1000 RPM'S I THINK THE IAC IS HANGING UP AND NEEDS TO BE CLEANED. ALSO WHEN THE THROTTLE BODY IS CLEANED IS THE IAC CLEANED AT THE SAME TIME. AND DO YOU HAF TO HAVE DIAGNOSTIC DONE FIRST
canister...does anyone have any info on whether they are possibly related...at 77500miles I am thinking it is far too early for these problems with a toyota
car will not pass emissions. Had sensor replaced one year ago. auto mechanics stated water was in the bottom of the car.
on my own. I have been told it will cost 450-850 to change a 35-40$ bearing. I need a honest person for help instead of paying out an extra $25-$40 for a manual. I wish the ones who say they are cert. mechcanics that cant answer a ? would get a life instead of wasting a mans time. Let me know how I can reach you? It will be a great help. Thanks for your time!
all wheel drive with ABS and how to repair
right side door mirror
I have noticed the Idle is below 1000RPM / around 850 to 900 RPM. Could this be do to a dirty Idle control valve and have recently read that it can be cleaned with a spray cleaner. Where exactly is it located and do you have any pictures of a step by step to do this ?
The car was running yesterday but today would do nothing more than idle. The check engine is on.