Under certain conditions, some models may shift into neutral even though reverse is selected with the gear selector. A software update to the Powertrain Control Module (PCM) will allow reverse engagement as long as the transmission has sufficient hydraulic pressure.
Software update to correct loss of reverse under certain conditions on Mitsubishi Raider
Average mileage: 108,161 (97,000–119,322)
Drive Trains affected: 2WD, 4.7L V8, 4WD
5 people reported this problem
3 people shared problem details
2006 Mitsubishi Raider- 4WD97,000Visitor
checking for a bad mount this morning. going from drive to reverse and back. all of a sudden no reverse. Matco scanner shows gear selected as reverse but actual gear as neutral. shows actual gear as neutral in park, reverse and neutral. all drive gears engage and shift properly.
2006 Mitsubishi Raider- 2WDVisitor
My raider will go in forward for about 150 feet and then it quits pulling all together. But it never pulls in reverse at anytime It is a 2006
2007 Mitsubishi Raider- 2WD119,322Visitor
I SHIFT INTO REVERSE AND THE TRUCK STAYS IN NEUTRAL HOPEFULLY IT ISNT ANYTHING TOO BAD
If the automatic transmission intermittently stays in second gear (will not shift into a highe...
After driving in Heavy snow, It Will not drive forward but will back up in neutral and reverse
On the 3.7L V6 and 4.7L V8 the Camshaft position sensor failure can cause the engine to crank b...
ac air wont blow out of vents it only comes out underneath the dash..
the motor does not operate at all, also is a fuse involved