GMC Yukon Problem Report
GMC Yukon Dead Battery Due to ABS Pump Not Turning Off
The anti-lock brake system (ABS) pump may stay running after the ignition is turned off causing the battery to go dead. Our technicians tell us that the ABS control module should be replaced to correct this fault.
Brake and abs lights stay on, abs control module needs replaced. Was told common problem. $1500.00 repair at local service center - Visitor
...lt one, but when I put it in all wheel drive, it changes to 4 wheel drive after I turn off the ignition, and then back on again. The shop that installed it can't figure it out.
brake and abs light on brakes work ok.
Typical ABS ECBM failure. Want to take module off and have it rebuilt. Just wanted to know wh...
The 4WD transfer case encoder motor position sensor or the selector switch may fail causing th...
I replaced the key switch now my Yukon will start and die I need to know how to reset the anyi thief system
I replaced thekey switch on my Yukon now it starts and dies I need to know how to reset the ant...