1993 Oldsmobile Achieva Questions
All 1993 Oldsmobile Achieva Questions
Ask a Question
Stop leak stopped problem. Reappeared after 3 weeks and "seems" to get into oil after engine is turned off. Overnight about 1 pint of water in oil by next morning. Car has not overheated in the past for as far as I ...
Motor runs but misses, what would cause it?
I have sat in my car while it rained and I could not see any water come in from underneath the steering wheel, but when I close my door and walk away for a minute and open my door the puddle will be on my floorboard. ...
have removed steering wheel found ignition switch and rremoved from end of key cylinder. turned ignition switch and car starts and stays running if i hold in right position.
this is my email firstname.lastname@example.org
My car wont start if it has been ran and the engine tempature is up. The starter does not engage. Do I need a new starter or could it be something else?
I refilled my freon in my car with r134 with an r12 attachment. Still doesn't blow cold but the compressor is turning. What could be the problem and/or fix? Thanks for the help.
My car was sitting for about 5 years with little driving in between to keep the engine and everything running good. Anyways, now my transmission is slow to downshift to 1st and sometimes slips out of gear going around...
My drivers side rear blinker is solid when turned on. The Hazards work fine and so does the right turn signal. I went to take the bulb out and switch it with the right to see if it was a bulb problem and the bulbs loo...
When my air conditioner is on, water leaks to the rear passenger floorboard, how do I stop this?
i was driving the other day and my care started to jerk and stall, i got the spark plugs rplaced and ignition coil replaced and still it stalls when i put in drive, have any suggestions?
i replaced the spark plugs and the ignition coil and still when i put in drive it stalls...what else you think it could be?
I am having trouble with the trabs shifting automaticly into drive I need to manually shift it, was told that it might be a transaxle sensor? any help would be appreciatted.