2006 Nissan 350Z Questions

All 2006 Nissan 350Z Questions

Ask a Question
Hi, I have about 112,000 on my car. I started hearing clicking noise when I turned my wheel when I'm at stop or driving very slow so I went to a shop and checked out what the problem is by lifting the car in the air. ...
I do not have a navagation unit but I do have the compartment and the door is all scratched up I have a new one and would like toknow have to replace compartment.
Was driving and the steering wheel got locked and then my car turned off, and 3 sensor lights came on the BRAKES, lts, and check engine light, took 3 attempts to turn on the car an suggestions First time this has happ...
Was driving and the steering wheel got locked and then my car turned off, and 3 sensor lights came on the BRAKES, lts, and check engine light, took 3 attempts to turn on the car an suggestions First time this has happ...
There is an space where the Nav unit would go. It's just above the radio. There is a door that covers the space it has a latch at the bottom in the middle. I want to take that door off. What do I do?
I need to know to reset the tire pressure monitors or must this be done at a dealer?
Cold mornings only. Tires are filled with nitrogen.
I have electric locks when I unlock my doors I still can't open passenger door with outside latch but I can from the inside with door handle.I have checked fro blown fuses but have found none. I can hear a clicking no...
I need diy instructions for center dash and upper storage door removal
How much will it cost in labor alone to get my master and slave cylinder replaced?
I was told that my 350Z needs a one time four wheel alignment to change the 'toe in'; required because the original set-up was designed more for racing; improve ride; quiter; safer for normal highway driving; True?
Knocking/tapping noise between 3000 to 3500 rpm. Not at idle or above 3500. Dealer says it could be a rod bearing. Sounds more to me like a lifter noise. Only has 40k miles & not driven very hard.