Close

2002 Mercury Cougar Questions

Get answers to questions about your 2002 Mercury Cougar at RepairPal. Find solutions, diagnose problems and get back on the road.

Refine by vehicle
×
Choose your vehicle
51
questions

i have a 2002 mercury cougar the belt keeps slipping off and the other day i was at walmarts and it made a weird noise and started smoking well i thought the belt had just came off again.......we were puttin the belt back on and noticed it had gotten so hot it put a crack in the radiator so im now in need of a radiator im curious what other make and models of cars will interchange with my mercury cougar?

The car has been doing fine except one day I had drove it bout 25 miles and it just did nothing but died going down the highway. The lights don't go dim so I figured it wasn't the alt. My battery post was pretty coroaded so I cleaned them really good. It makes me mad because I just bought this car from a car lot and haven't had it bout a couple of week's and it all of a sudden started doing this. Please help me figure this problem out. Also it won't turn over after it dies for at least about five or ten mins. Then it will start rite back up.

It acts like it wants to start but it doesn't

I have transmission oil in the antifreeze tank and it doesn't run good

Just put new thermostat and waterpump and housing on.

Car goes to H & then up & down. Replaced-water pump, both H/C sensors, flushed 5x, heater core. Hose split & antifreeze everywhere thurs. Did it again yesterday but a diff one. Code reads ECU Any advice? 2002 mercury cougar- Manual- 4 CL. ADVICE?

it looks like a fan or a snowflake

have re placed the egr valve , fuel filter, mass air flow senor.it is reading codes po174 po300 po305 po306

HAS PLENTY OF FLUID AND DOESNT SMELL BURNT SOMEONE FROM 4 1/2 YRS AGO SUGGESTED IT COULD BE PCV VALVE RATHER THAN TRANNY ISSUE ANY HELP WOULD BE GREAT. JUST STARTED THIS WEEK THANKS BRIAN

Won't shift passed second gear

new coil, cam sensor, crank sensor, fuel filter,fuses. Still wont start. need instructions for ecm test and timing chain test.

When changing the crankshaft and camshaft sensors is it necessary to time the engine before it will start? My engine still wont start.