2001 Mercedes-Benz S600 QuestionsRefine by vehicle
After having my auto alternator installed the Oil level turn on showing low oil level. A dip stick showed oil level full at 120ml. What is the cost for parts and labor ?
Shaking at stop an slow takeoff but there is no check engine lite coming on
when my car is park the driver side sits lower than the passenger side
front end comes back up when prompted by pressing the button--car had driver side coil pack and plugs replaced but still does not accelerate as it does
for the last 2 years, check engine light on 4 times, each time replacement of all 24 mercedes spark plugs, I only drive in city short distance only 3000 miles each time, what is wrong ? can there be another part problem ?please help Thanks
And used A001 989 21 03 10 ATF... seems the car is in limp mode??? How do I get it out of limp mode??
how do i play a cd in the radio
Diagnostic Trouble Codes:
P0311 P0312 P0308
Local Mercedes dealer's diagnostic included compression
test's result was no compression in Cylinders #11 & #12
and they recommended to take heads off for further analysis.
I had the left coil bank replaced and no luck.
My question is:
IS A FAULTY MASS AIR FLOW (MAF) SENSOR
CAUSING THE MISFIRE/ERRATIC/ROUGH ENGINE RUNNING
SINCE THE MASS AIR FLOW SENSOR MEARURES THE ACTUAL AMOUNT OF AIR ENTERING THE MOTOR AND THE ENGINE CONTROL MODULE (ECM) IS TAKING THE WRONG INFORMATION AND DELIVERING INCORRECT VOLUMES OF FUEL TO CYLINDERS #11 & #12?
My S600 heat up to a certain temp and shuts off, and has to sit for about 3 hours before I can start it again.
the radio is look is working
all the is coming up actve body control (abc)
The car is very slow to get to speed. does not seem to misfire but lost of power. could the converters be stopped up?
As I'm driving the car, the SOS take to workshop message comes on and goes off. It does this randomly, what could be the cause?
Every morning when I trun the car on the ABS warning message comes on. I have turn the car off then turn it back on and the message will go away. What could be the problem?
Dealer diagnosed problem latch vacuum actuator split and leaking.
Does anyone have repair solution and how it can be done.