It will turn over like it wants to start, but will not start.

does the rubber nipple need to be on the end of the rod

Vehical starts and then dies right away, doe not matter it you put your foot an the gas or not. Im sure it is the fuel pump but one guy at the parts store says its a mechanical pump and another says its in the gas tank.

put a new brake booster on and plug brake light swicth up and it worked but wood not go off so unplug them and now they want come on

wont start has new fuel pump,crank sensor,map sensor,plugs wires and cap

i am planning on repairing my head gasket myself.(or at least do whatever parts i can.) is there anywhere i can get a complete breakdown of how this is done, what is involved. preferrably a step by step walkthru.
i cannot afford a replacement vehicle or a shop so i am left w/doing the repair myself.( there is only a minor oil leak along the passenger side of the engine) so far it runs fine but i would rather fix it now before it internal damage occurs and/or im left stranded w/o any vehicle at all.
i understand there are some procedures that must be done by a shop. everything else i can handle myself. i would greatly appreciate any info anyone has to offer.

my straight 6 engine is seeping oil out the passenger side along the seam where the head meets the block. about a quart every wk and a half. otheer then that it runs fine. what can i do on my own? by a shop? estimates?, and is it even worth it money wise? any thoughts and opinions would be grateful.


i have a 89' laredo none of the guages work such as rpm, oil press, temp, volts only guage that works is speedodmeter took out guage panel no broken wires or nothing checked blade fuses. Any help would be appreciated someone pleas help

after warm up engine will not kick down . vehicle hard to stop with such a high idle

It always worked good before,one day just stopped(4-wheeldrive)

I have had my Jeep worked on twice for the same problem and it still occurs. After driving about 50 miles it loses power and eventually I have to pull over. If I wait a few minutes, I can drive again, but with reduced power. Who should I take it to that can really resolve this problem and not just say it is fixed and charge me for their time?

took my jeep in for an emission test and the reading came back with high CO readings.

i have replaced the starter 3 due to something i thought it was the battery and that was not it i replaced that before the starter but i thought it was the alternator they say no so why does the starter keep going out if every thing else is good i also have had gas issue i replace the filter and gasoline to valareo and it works better but i needs alot of advise on this truck where do i go what i do

The rear passenger door handle is completely shot -- I have to duck tape the door closed to prevent the lights from staying on -- the other rear passenger door is starting to have similar "latching" problems. Am I the only one? AND, I can't seem to find a repair estimate.... Anyone?