Engine Will Not Start Due to Blown Door Lock Fuse on Dodge Ram 2500

If the engine cranks but does not start, or starts and stalls, the fuses should be inspected, especially the power door locks fuse. The power door lock fuse provides power to a module that sends the Powertrain Control Module (PCM) the "OK to start" signal.

RepairPal Verified
Average mileage: 145,733 (120,000–195,000)
4 model years affected: 1998, 1999, 2000, 2001
7 people reported this problem
2 people shared problem details
2001 Dodge Ram 2500122,200
Starts one day, then maybe not the next day. when fails to start, it acts like it wants to, then when you let off the key, it will try to run. we replaced the oxygen sensor
2000 Dodge Ram 2500120,000
Engine would crank but would not start. Swapped the fuel system relay switch located in the fuse box with the spare that is supplied there and it cranked right up.
Related Items:
If the engine does not crank (or cranks but won't start), the wireless control module (WCM) may...
spin engine over trys to hit but wont start,can continue to spin engine and it will crank, can...
I know in the old days the dodges had a way about starting up an engine and that would be where...
Dragging on it. Once it starts it dies unless you hold the gas down. I have replaced my MAP SENSOR AND STARTER. The battery is new and has been checked out. It shows no codes on a diagnostic. No o...
cranks 1st thing each day, after engine gets warm, will not crank until it cools off,(cold days...

Related Content