1991 GMC Suburban 2500 Questions
Get answers to questions about your 1991 GMC Suburban 2500 at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
Starter died trying to start with dead fuelpump, both are replaced starter switch is good, new starter+pump work. But it still won't get fuel, maybe the fuel sending unit? I keep hearing people suggest the distributor, but it just had a tune-up and ran buetifuly
There is a little black box it sticks out in the engine bay that gets hot I think that is a problem I do not know the vehicle will not start after running for a while!
a engine quit runing wait about ten minutes engine start i was towing a trailer the engine just stop runing wait about ten minutes it star running again drive about one hundred miles it stop running again wait about ten minutes start again.
transmission shifts through first, second & into third then stays in third. i am wondering if this could be related to towing. i have owned this vehicle for 170,000 out of it's 230,000 miles & only just recently towed a 2500 lb trailer of firewood. now suddenly i have a blown head gasket & transmission that won't go past third.
air bubbles back through coolant resevoir constantly pushing coolant into the reservoir & not allowing it back into cooling system thus causing "low coolant" light to come on.this happened after an overheating episode when i noticed my temp go up to about 210 briefly. i immediately replaced thermostat & radiator which was leaking a little. the bubbling reservoir started after these repairs.
i have can you tell if its your brake boost thats gone bad or your master cylinder
i have a solid axel 8 lug front. replacing ball joints on driver side. how do i pull the axel to get to the ball joints?