14
questions

Radiator had pressure built up prior to taking cap off, was very low. Overflow tank was VERY full. When running after filling radiator noticed a lot of small bubbles in coolant, almost looked like carbonation in soda style bubbles.

The linkage between clutch pedal and puchrod for clutch master cylinder has an issue. I can grab part where linkage for clutch master cylinder connects and hold it but clutch pedal moves without the part moving that I'm holdind that linkage for pushrod connects to. Its like a pin or other part is broke stripped out or something. This is first time for me dealing with clutch ever, every thing else is in working order except between pedal and where clutch master cylinder pushrod is connected.

I was plowing yesterday morning and I went to the gas station to get diesel I get in to leave and put it in gear and no motion what so ever just a little crawl .. I added some aft and was able to drive about 5-6 miles and leaked out again I stopped and looked under and it's just pouring out of the drain on the bell housing what seal would that be????? Please help

On a Ford 8000 chassis,where is the clutch master cylinder located?

Sometime the engine cranks easily and the next time it will hardly turn over.

oil is blowing out of pipe going into engine

I need to see a manual on engine relays and the fusses it cranks but won't start.

Has three trucks in one so I could be getting thrown off I was not the one who put the truck together. Thanks anything helps

our 91 forn e 350 just dies in the heat

both battery are good/ alternater tests goob/shows 14.2 charge rate at battery/starts runs good. checked the fuses checked for bad gound/ e-mail / thanks twostreet53@gmail.com

both battery are good/ alternater tests goob/shows 14.2 charge rate at battery/starts runs good. checked the fuses checked for bad gound/ e-mail / thanks twostreet53@gmail.com

Can anyone tell me where the windshield washer pump is located? Thanks!

i'm looking for the plate that holds the fipl sensor.

problem finding the oil sending unit