Took to FF Tire to see if they could find out why it was leaking transmission fluid and to check ...
Q&A
Ask Your QuestionAll 1997 Ford Contour
Question
FF Tire replaced serpentine belt, it broke within warranty, $80 job now $1399
Rookie
0 Answers
Flag This
Link to Question
Question
What does it cost to replace the lower ball joint on the passengers side
Rookie
The lower ball joint needs to be removed and a new one installed
1 Answer
Flag This
Link to Question
Question
what is trouble code Po420 the check eng. light keeps coming on in town driving
Rookie
No check eng light when driving on long trips. Only in town
1 Answer
Flag This
Link to Question
Question
How do I change a front transmission mount?
1997 Ford Contour, 2.0L 4 Cylinder, Traci_8301, Deer Park, TX, February 21, 2012, 11:07
Rookie
I've tried looking for it in my chilton book, but I can't find it anywhere. I changed t...
0 Answers
Flag This
Link to Question
Question
how long should it take to change 2 outer tie rods and 2 lower control arms?
Rookie
The bushings are bad on both tie rods and both control arms.
2 Answers
Flag This
Link to Question
Question
I'm having trouble with the steering, thought it was low on steering fluid.
Rookie
I put the fluid in the engine coolant recovery resservoir instead. Problem is I can not drive the...
0 Answers
Flag This
Link to Question
Question
car runs hot, has new radiator, lines were flushed out new thermostat
Rookie
car runs hot, has new radiator, new head gasket, new thermostat.
1 Answer
Flag This
Link to Question
Question
rerplacing parking light assy
1997 Ford Contour, Runner01, Richmond, VA, June 15, 2011, 11:25
Rookie
Mine was broken. I need to remove and replace the assy. for state inspection. Have no idea what...
1 Answer
Flag This
Link to Question
Question
power window
1997 Ford Contour, Visitor, Leesburg, FL, June 09, 2011, 07:36
how do I repair the drivers side window myself
1 Answer
Flag This
Link to Question
Question
powertrain control module
1997 Ford Contour, 2.0L 4 Cylinder, ktoms2000, La Habra, CA, May 19, 2011, 14:30
Rookie
where is the power train control module located?
0 Answers
Flag This
Link to Question
Question
19997 ford contour want take off in drive but take off in drive one
1997 Ford Contour, 2.0L 4 Cylinder, Visitor, Windsor, NC, April 05, 2011, 15:23
just started but transmission makes a little noise
1 Answer
Flag This
Link to Question
Question
where is the maximun air flow sensor located?
Rookie
engine idles rough I wwill like to know where is my maximun air flow sensor is located?
thank you...
1 Answer
Flag This
Link to Question
Question
Transmission not shifting.
Rookie
Drives great under 40 mph above that it acts like it dont know when to shift.Had code read it cam...
1 Answer
Flag This
Link to Question
Question
how to change the speed sensor on transmission
Rookie
It drives fine under 35 mph over that it dont shift right it jumps all around like its not sure t...
1 Answer
Flag This
Link to Question
Question
How do I access upstream sensor?
1997 Ford Contour, 2.5L V6, Visitor, Tulsa, OK, February 22, 2011, 17:31
sensor located in exhaust manifold. Do I take off the coil pack & get at it from the top?
2 Answers
Flag This
Link to Question
Answer Ranks
This week's top 10
| 1 globalhelper | 6 goodguy |
| 2 wetry | 7 ebans777 |
| 3 ziptie12 | 8 Superior Auto Diesel Repair |
| 4 wenyan | 9 FREDDY BLUE |
| 5 tunnelram | 10 team g performance |