Get the latest advice about your car

Get Started
Advice » Problem Reports » Failed Door Ajar Switch Due to Corrosion

Problem Reports

Chrysler Sebring

Report: Failed Door Ajar Switch Due to Corrosion

Chrysler Sebring Problem
6 Reports
Me Too Edit

Model Years Affected: 1997, 1998, 1999, 2000

Electrical & Lights Affected: Coupe

Average Mileage: 138,666 mi (114,000 mi - 182,000 mi)

Verified

Corrosion on the door ajar switch can cause the door ajar warning light and dome light to work intermittently or not at all. A new switch (and possibly a new connector) will be needed to fix the issue.

Add to My Checklist
Find a Shop
  • Report #1
    Visitor, 1999 Chrysler Sebring, 182,000 mi

    My door ajar light stays on all the time and my dome light does not work. It has been like this since it had 90,000 miles on it. I lubricated the door lock when it firs started this and it didn't fix it.

    Flag This
  • Report #2
    Visitor, 2000 Chrysler Sebring, 120,000 mi
  • Report #3
    Visitor, 2000 Chrysler Sebring, 114,000 mi

    when i open the right door on my convertible the dome lights dont always come on. how do i fix/repalce this?

    Flag This
Related Items:
  • fail safe
    my chrysler sebring one day the engine light turned on and it would only saty in third gear. I was told it was in fail safe mode, now i can put the car into drive, low, reverse, & neutral. but it w...

    Q&A > Chrysler > 2002 Chrysler Sebring

  • OIL PRESSURE SWITCH
    I have a leak coming from the oil pressure switch. I've bought and changed out the switch 2 times which I had bought from AUTOZONE. I am not sure if I may need to put more teflon tape or if any ...

    Q&A > Chrysler > 2004 Chrysler Sebring

  • oil pressure switch location
    Hi, I need to replace the oil pressure switch in my chrysler sebring convertible touring 2.7 v6. I am not sure where it is located. does any...

    Q&A > Chrysler > 2006 Chrysler Sebring

  • brake lights will not go off
    Brake light will not turn off and draining battery

    Q&A > Chrysler > 1998 Chrysler Sebring

  • p0335 code, will not start
    This is a 3.0 LXI coupe model. The car would not start, then after a few cycles of the key started up. Now it will not start at all. I replaced the crankshaft position sensor and have the car toget...

    Q&A > Chrysler > 2001 Chrysler Sebring

Ask a Question