Engine problems due to intermittent connection in crank position sensor wire connector on Dodge Ram 1500

On the 3.9L V6 and 5.2L V8, an intermittent connection in the crank position sensor wire connector can cause poor engine performance or the engine may crank but not start.

RepairPal Verified
Average mileage: 198,000 (198,000–198,000)
3 model years affected: 1994, 1995, 1996
6 people reported this problem
2 people shared problem details
the connector to crankcase position sensor is defective...
My transmission went out and so i bought a used transmission. Rebuilt but. When i fired it up an put it in reverse. The engine. Completetly shut off. No fire or fuel pressure i notice the ,ain transmission. Harness had bare wires and a few were touch each other i separated. The wires and rrpaired them i replaced the ecu thinking. That i burnt it but still nothing is it possible. That i burt the sensors in the valve body causing the motor to turnover but wont start im lost dont know what t do next
Related Items:
I have a engine wiring problem with my 1994 Dodge Ram 1500; When I drive in forward gear the en...
The starter cranks but will not start. If I spray fuel into the intake it will run. If i leave...
the plug receiver you plug the o2 sensor wire into ripped off when muffler pipe came off,do not...
Replaced idle air control. How do I test auto shut down relay, crank position sensor. Could pic...
the engine it's a 5.9 v-8 ,shuts down when it warms up,it wont start back up till it cools down...

Related Content