1995 Dodge Caravan QuestionsRefine by vehicle
Van gages lite was on tookl van in for emission test.Did not pass test.Replaced o2sensor.Ecm.Coolant sensor ,speed and map,Ins cluster. andThermostat, BCM,SBE controller Throttle Pos,All other sensors check good according to the Haynes Book.The Van passes all emissions test with great ratings like a new Van.The check gages lit2 stays on and I have no Fuel And.NoSpeed od and no temp gage . All lites function.Van runs great Just no gages.Book says reset EMC lite on ins cluster with D R B ll scan tool.Mechanic says OBD ll.And that, that will not fix it.Wants $150 to test it and keep it for a few days.All I need isSchematic showing Check gages wireing And a DRB ll scan tool or some one I can trust.
I replaced master cylinder and bleed brakes. seems to have some brakes with the engine not running but when you start it no brakes at all
Can't get to freeze plug behind motor mount
are turning slightly or running 55 mph or more. These tires came from a tire center.
The outside handle has come off and the inside one won't open it.
top one to motor cannot find where to hook up the other one. hose is about 3/8 inside also there is a hose coming out the fire wall it has been cut do not know where it goes
2 hoses on crankcase bottom one seems to go no where
These are no brackets manufactured by Dodge for this model, and I have not found an after-market version on the web. I have been referred to junk yards, but junk cars in my small town in southern Alaska are all re-cycled to outside salvagers. Any help?
My Dodge 95 starts when it is Cold. But when it gets Hot, the fuse to the PCM, burns out. I narrowed it down to a Red/White wire from the fuse box to the PCM.
I cut the wire it does not blow the fuse.
I hooked it back up and the fuse blows.
Or what else could it be.
Do you think the PCM is Bad.
Or what other electrical components hook to that Red/White wire that goes directly after the fuse Box on the Red/White wire.
heater blows cold air
turn the key and the starter relay under hood hums everytime you try to start,has power but will not crank the starter
when it stop , i turn the ignition but does not stay on , but after ten minutes it turns on and stays on
i was told to replace the freeze plugs but have no idea where they are and which ones to start with. i have refilled radiator a few times since i noticed this problem.
what else do I need to remove besides the balancer. Do you have a film or photo