2006 Chrysler 300 QuestionsRefine by vehicle
where it gives the temperature, the direction will not appear. It's a 30 touring
When I purchased the new throttle body it had a note that some models require a relearn procedure. What is that procedure?
I have tried changing the spark plugs coil oxygen sensor i removed the code and it came back on I don't kno what else to do Im trying to do all I can to avoid taking it to the shop could u help me plz
Was in a car accident. Was hit all my left side of car. Two days later my car shuts down. Btw.... Car was running just fine before accident. I take it in to shop and they replaced left side fuel pump. Can this damage been caused by accident?
When I stop it will continue as it should
My steering wheel and brake pad gets really stiff and when I change gears the car basically does what's the problem?
also I used to hear the door close when I would switch to AC no long hear it.
goes off when i go over 120 km the light comes on again and remains on when i slow down i have to pull over turn the car off and re start it the light goes off again can you tell me the pwoblem thanks
I was told it was the fcm could it be any thing else if that's not the problem
Even when I release parking brake it stays on. This happens most of the time but not always
I can't get some stuff inside my car to work even though I set the settings. Like the lighter/power source and the automatic seat entry mechanism.
Water has gotten into the car key, before we noticed, we tried turning the car on. It turned on for a second and then cut off. Now it won't start at all. How can we fix this?
Codes r-P0606-internal control processor, P0300- multiple misfire, P0335- crankshaft position sensor, car will run for a minute then stall, replace battery, replace crankshaft position sensor, replaced cam position sensor, replace integrated control module, I just bought the car an it drove fine when I looked at it an then drove down the street an now only runs for a min before stalling, it sat for a few months, no rat damage or any other sign of wire damage, feels like chasing a ghost, grounds r all clean an tight
NO START CONDITION DEALER DIAGNOSED TRANSMICCION CONTROL MODULE
Only my lights turn on when I turn my key. Power is strong with engine and red lighting bolt comes on. Just the engine will not turn on. Also if If I hot wire the starter the car will not turn over. It seems like the gas is not getting to the engine. I hear the gas pump turn on. Whas up?