1993 Chevrolet Suburban 2500 Questions
Get answers to questions about your 1993 Chevrolet Suburban 2500 at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
but now brake light will not go off.Ebrake. how shoul i trouble shoot,what should my concern be?
Turned car on just fine and when I went to turn it off the ignition wouldn't turn bad over to turn the engine off. What could it be
I was driving the truck around town I had used reverse I pulled into a parking spot and a when i went to back up nothing happened it doesn't even feel like it is going into reverse.
When driving over 35 mph the engine temperature seems to be fine. Once I come to a complete stop the temperature starts going up. Once the temperature gauge needle reaches the half point the fan noise gets very loud when I accelerate & the truck looses a lot of power. Slowly the needle starts creeping higher and higher until I start driving over 35mph again. There are no leaks. Coolant level is at its normal level. I also checked the radiator cap & looks fine. The thermostat seems to be working as well. Also there is no white smoke coming out of the exhaust pipe. The Suburban has 45,000 original miles on it. Please help thanks
The ABS light is still on after replacing brakes.
you can feel it drop in but don't move
I have a 1993 Chevy Suburban 2500 that has a bad ECM module and it has been 3 weeks now but not fixed so how much time should it take to fix/replace and how much should it cost me.
With the A/C selected on HVAC panel. The HVAC blows warm air. The A/C compressor clutch does not engage. Has R-12. What else can I do asa backyard mechanic?
There is too much play in the steering & there is a groaning sound when I make turns.
step by step instructions on how to replace the heater core
Lights on 1993 suburban are not working right,head lights work ok,brake and tail lights work until head lights?
are on then don't work,turn sig work at reg speed until brake is applied and then speed up and only front signals work, backup lights do not work at all, I have replaced the head light switch and all bulbs and fuses are good. When turn signals are on, the license plate light now blinks. All this happened at one time, I can fix it if I know what to fix. Thanks
PULLING OUR BOAT TO THE LAKE, UP A SMALL INCLINE, AND THE ENGINE STARTS TO CUT OUT. NEVER DONE THIS BEFORE. PULLS THE BOAT FINE, RUNS AROUND TOWN AND ON THE FREEWAY FINE, JUST NOW STARTING CUTTING OUT WHILE PULLING OUR BOAT.
well my suburban hasnt been driven for a few mnths.In the past i push the brakes and the lock up rarely. now when the suburban is moved around the block once a week the just lock everytime u touch the pedal. im bringing the vehicle to alaska and dont want them to lock up in the snow or on the ice . what do i do to fix the problem
i wanted to know 1st what where some of the serious problems that have occured for this year as far as recalls if any and two i have a problem with the left rear talight where the signal and brake light dont work just on left rear some one had said it might be the actuall board back there where the bulbs plug into? whata you guys think all lights are working on the right rear and all in front on both sides it is only the brake/turn that dont work there are 3 lights back there on the left only 2 of the 3 work we tryed the flasher and bulb both are good and we tryed the fuses under dash and under steering column....what do you all think?
I have a 93 k2500 used to have 454 someone put a 350 in it and when you hook it to a computer it comes up with est problem timing does not change when you hook up the electric advance wire i think it still has 454 computer in it will this cause my problem and how do i get the right computer for it