1996 Chevrolet Corvette QuestionsRefine by vehicle
Engine is LT1. Transmission fluid is leaking from rear of transmission.
car would shut down untill it cooled down then would restart.code p1351 icm was only code. i replaced the icm which solved the problem but the service engine light is still on and still reads that code and wont reset whith scanner.
The beeping sound also happens when car is running.
Passenger side floorboard gets damp when using a/c. There is very little water drainage under car.
I have had this car for 3 years and I have probably put 125 miles on it.It has right at 91000 miles on it and I stopped to put gas in it well I did not put the 93 octane in it.After driving it to church and then back home I noticed the service soon light was on.Where do you think I should start looking or can someone point me in the right direction for an answer to my problem?
Car been sitting for some years and now wont start because fuel not igniting
replacing serpentine belt,,took old off ,new one and checked for size its the correct one ,,pulled tensioner back all the way wont slip over alternator by 1/2" routed correctly checked that ,,so close but not close enough to put on
How do i and remove the body or shell from chassis from the 96 corvette. IM parting out all body and interior and i want more room as i remove drive train the parts i want ?
This mech. works fine until the car is exposed to the Phoenix heat. When left out in 100 an up weather the hatch will not open. When parked in garage or it cools down the Hatch works normally.
The indicator light was coming on and my tires were fine. Chevy said they didn't make parts to fix. Is this true?
I was told that my suspension is only on touring. The other settings are not available and chevy do not make parts to fix. is this true?