1990 Chevrolet 3500 Pickup Questions
Get answers to questions about your 1990 Chevrolet 3500 Pickup at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
I have bled the clutch slave and still have no clutch .How can I tell if the master cylinder is the problem. There is a little clutch but not enough to drive it. Had this trble before but bleeding slave cured it .could the slave line have rust in it and what is the cost per part? THKS BEN 1989 yr
power steering box, power steering pump and hydro vac brake booster were all replaced and the whole system was bled out
we have power to all the wires on the disturber but the purple wire, the engine will turn over but will not start what can we do now?
Give me a diagram showing how the oil cooler is hooked up from engine to radiator, Chevy 1-Ton truck 3500 silverado 454CID engine, extended cab new body style auto transmission air condition VIN # 2GCGC39N4K1229116.
does thge seat go through or ontop of the cvlutch fork
all cylinders lost compression. replaced worn-out timing chain and gears. still 0 compression in all cylinders. whats the likliness of all the valves getting bent and staying open. seems there should be some compression in any givin cylinder even if the timing was off. the crank gear is set at 12 o clock the cam gear at 6 o clock..... baffled
should I replace my hydro booster. And how do I bleed my breaks. Is there some trick I am missing. The breaks just won't bleed is it normal for air to blow bubbles into my power steering pump when I push break peadal to the floor.
87 chevy one ton 4x4 with 454 had fluid leak at gearbox. replaced gearbox and filled with fluid now i have no assist.
Does anyone of the Master Techs out there have any labor guide links they could forward for some of the items that are not covered in estimator link? I no longer am at a shop where I could look this stuff up. Common one seems to be belt tensioners. Thanks...
That you know of do these work? Did recent head gaskets, surface head, valve job, used Fel Pro head set, did not use any sealer on head gaskets when reassembled, when sits overnight and restart after runs for a bit can see some white smoke out tailpipe, nothing like when gaskets went completely out, losing small amount of coolant, pressure test shows no signs on ground, thinking about using head gasket repair in can to try to seal against white smoke. Any suggestions. Am retired ASE Master Tech. Thanks
Why does the air in my truck just exit the floor vents when my defrost is on?
brake lights not working
I need the location of the dash light blubs on my 1990 chevy ck3500 pickup
I have a 454 1983 itaska that overheated. it still runs strong and dose not knock in neutral. what can I do?
My truck temperature tends to rise when go about 70 MPH. I flushed the system, replaced the thermostat and the clutch fan. I also pressure washed the radiator's fins.