2003 BMW 325i QuestionsRefine by vehicle
turns over but fails to engage/start wants to start almost starts what is the likely issue
I had brakes replaced at meineke roughly 1,000 miles ago (all 4 pads and rotors). The brakes will squeak the moment they are pressed then stop and continue when speed drops to 5 mph through a complete stop. Sometimes, mainly when it is cold I also can hear grinding just before the car comes to rest.
so i went online to review problems with overheating and followed the procedures on how to determine the problem, so i turn the ac on full blast to see if the fan turned on in which it did not ..it looked as if it wants to turn. how do i determiine if its the motor or the fan relay switch?
What is the likely issue and is it a DYI project?
I supposenly had the valve cover replaced. I am beginning to wonder if the job was done. I am at the mercy of the mechanic who did the work. I had a burnt oil smell come from the vents when the heater was on. How would I know if the valve cover gasket was replaced. Should I have it replaced again to be sure. Will replacing the bolts fix the oil leak?
aveces no estartea y vota humo, como hago para mirar el motor de arranque, no se ve..
also so hear a clunk noise in rear,,i get outside car and push down on car in front and rear but hear no clunk then,,and by the way on front pass side just replaced sway bar link..
what is causing problem?,,the rest of the day runs great
I have a 325i 2003 bmw .transmission Does not shift from 1-2 until 3500-4000 rpm when cold (during initial take off from setting overnight or at work all day). Works fine once car has been driven couple of miles.Any ideas?
the flashers just come on for no reason, several times a day. what causes this?
Battery is only 1 year
and other related parts is there a diagram available
what would cause this problem
my mechanic said that i should replace the power steering pump 1st and then see if i need to replace the rack and pinion. how can you tell if it's the one or the other in 2003 325i bmw. the fluid is ok and it doesn't make any other noise. If i replace the pump should i replace the pressure hose too. He's saying it's not necessary to repl hose