2003 BMW 325i QuestionsRefine by vehicle
There are no oil leaks and it is not burning oil through exhaust Any suggestions?
we were only in the car for less then 30 min... i could smell it and when my son got out if the car it was mekted and burned!
Bad vibrating sound when I turn the wheel either way ?
What could be causing this and how do I fix it?
The windshield fluid tank was leaking after a period of being dry the tank stopped leaking when refilled. Now the spray motor has stopped working. Any suggestions?
I have the glove box out but apparently the tunnel does not come out...Is that true?
I have power at the injectors and 51 psi on the fuel rail but it doesent seem to be getting fuel. what might the problem be ?
could it be a fuel pressure regulater ,I do hear a hum at the engine when I turn key on but do not hear a hum at the tank.i poured gas in the intake and it started right up
don't work the sound seems like its comeing from the glove box area plus I smell a plastic burning smell not all the time but a lot...if I use the key to unlock the door the head lights come on...some times the remote key works now the only time my fog lights work is if I put on the reg. head lites
shop replaced mass air flow and 02 and 05 sensors also had previously replaced some coils..what other repairs are need to completely fix this problem
Sunroof has not been used in 2 years due to fear of not being able to close. When opening and closing makes loud cracking noise. Not sure if water leaking from sunroof into car though some internal passage...cloth around back and front panels loosen as if from moisture.
turns over but fails to engage/start wants to start almost starts what is the likely issue
I had brakes replaced at meineke roughly 1,000 miles ago (all 4 pads and rotors). The brakes will squeak the moment they are pressed then stop and continue when speed drops to 5 mph through a complete stop. Sometimes, mainly when it is cold I also can hear grinding just before the car comes to rest.
so i went online to review problems with overheating and followed the procedures on how to determine the problem, so i turn the ac on full blast to see if the fan turned on in which it did not ..it looked as if it wants to turn. how do i determiine if its the motor or the fan relay switch?