ABS Light Due to Control Module Failure on Cadillac Seville STS

The anti-lock brake system (ABS) control module may fail causing the ABS light to illuminate. Failed modules should be replaced to restore ABS operation.

RepairPal Verified
Average mileage: 125,074 (65,000–220,000)
14 model years affected: 1990, 1991, 1992, 1993, more1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
36 people reported this problem
12 people shared problem details
Traction control and ABS lights stay on dash. This is due to ecbtm Module gone bad. replace Module and this should fix the problem. You can go by the VIN and buy one used.
Upvoted (15)Flag inappropriate
light came on due to right rear caliper over extented
light comes on for a while then goes away, drives us crazy
Abs light stays on
abs light on. Still on.
abs light stay on
Anti-lock brake and traction control lights on. I can't find the right module location.
Abs and traction on
my dash board light goes on and off
ABS brake module issue along with Engine light.. Not sure what is going on
Just bought the car and need smog and brake light inspection both test don't past due of ABS Light on, too much money i spend still not able to drive the car...
In my case the problem is don't build cars where the battery is that far away from the engine.All leads to ground problems big time!!!!!!!!!!
Related Items:
My blower fan is not working. Where is the air control module located at for a 1992 Seville STS...
My brake light fuse keeps blowing any idea where to check for for a short or short to ground? My cruise control always works when I turn it on but after about 5 minutes or when I hit the brake o...
The car is actually a 1991 Cadillac Allante, where is the Controller for the ABS system located...
Had a new transmission installed in my Cadillac. When I got it back the cruise control no long...
keyless remote, powerlocks, back up sensor, trunk release, gss latch release, interior lights c...

Related Content