The windshield wipers may not work intermittently due to a faulty wiper motor control board. Our technicians tell us that lightly taping on the wiper motor when the fault occurs should temporarily get the wipers working again. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.
Windshield Wipers May Fail Due to Faulty Wiper Motor Control Board on GMC Yukon
Average mileage: 158,308 (98,000–298,233)
14 people reported this problem
4 people shared problem details
1994 GMC Yukon298,233Visitor
was not fix and dealer tells me that my vin number don'fall in under the recall
1997 GMC Yukon102,000Visitor
Intermittents wipers would not run (wipers either ran or not). Replaced control board
1999 GMC Yukon98,000Visitor
Pressed/moved plug to control board. No permanent fix yet.
1999 GMC YukonVisitor
Wipers work when they want. When they do work sometimes they just stop and won't start again. Almost hit someone walking because it was dark and rain was pouring. Had pulled over twice trying to get them to work.
How do I remove/replace the windshield wiper motor on the 2003 Yukon?
my Windshield Washer Reservoir Bottle is probably leaking as the whole system is working fine e...
How difficult is it to change out the front heater blower motor on 99 yukon? Making noise and...
After turning the car off, the drivers seat motor is humming as if it is stuck. The only way t...
SERVICE RIDE CONTROL LIGHT CAME ON, STAYED ON FOR 2 DAYS...WHILE ON STEERING FELT VERY LIGHT AT...