Get the latest advice about your car

Get Started
Advice » Problem Reports » Wear In Outer Tie Rod Ends Can Cause Steering Problems

Problem Reports

Oldsmobile Cutlass Ciera

Report: Wear In Outer Tie Rod Ends Can Cause Steering Problems

Oldsmobile Cutlass Ciera Problem
7 Reports
Me Too Edit

Model Years Affected: 1990, 1991, 1992, 1993, 1994, 1995, 1996

Verified

The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.

Add to My Checklist
Find a Shop
Related Items:
  • valves and push rods alignment
    ...osition of the exhaust and intake valves and their push rod alignment(s) on the head of a 1995 oldsmobile cutlass ciera v6 3.1L engine?

    Q&A > Oldsmobile > 1995 Oldsmobile Cutlass Ciera

  • Car stalls while driving
    The past 2 days my car will stall while driving about 10-12 miles. Yesterday it would only go a mile or so before it stalled out. Usually after aminute or so (few minutes sometimes) it will fire ri...

    Q&A > Oldsmobile > 1994 Oldsmobile Cutlass Ciera

  • Steering wheel problem
    Lately I been having problem in turning the steering wheel been having problem fighting with the steering wheel sometimes it will not turn and at times when I do seem to turn the steering wheel it ...

    Q&A > Oldsmobile > 1996 Oldsmobile Cutlass Ciera

  • 1993 Cutlass Ciera Oldsmobile fuse / relay problem? Frozen gas lines
    It snowed, and was freezing outside.Tried starting my car (1993 Olds Cutlass Ciera) 2 days in a row,..but nothing. Got a new battery last night, because I ran the old one down trying to start it. T...

    Q&A > Oldsmobile > 1993 Oldsmobile Cutlass Ciera

  • burnt end at the connectors of the wire harness
    What causes a shorting out of the wire harness and where can I get a wiring diagram

    Q&A > Oldsmobile > 1993 Oldsmobile Cutlass Ciera

Ask a Question