» » »

Car Recalls

Recalls are issued for cars with safety-related defects or problems

1994 Volkswagen Jetta recalls

 

Brakes, October 15, 1998

Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR BRAKE LINE ON THE PASSENGER SIDE WAS ROUTED TOO CLOSE TO THE CORNER OF THE FUEL TANK. THE LINE COULD BE DAMAGED BY CHAFING AGAINST THE FUEL TANK.

Learn more »

Body, Interior & Misc., October 15, 1998

Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS SECURING THE FRONT HOOD LATCH CAN LOOSEN OVER TIME. THE LATCH WOULD MOVE CAUSING DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH.

Learn more »

Body, Interior & Misc., November 18, 1996

RepairPal Expert Overview:

Volkswagen has recalled certain 1994 Jettas because the sheet metal panels of both rear doors have sharp edges that can damage the insulation of the wiring harness. This can cause an electrical short, which may result in a fire. Dealers will install a protective edge cover in both rear door inner panel openings.

Learn more »

Engine, November 29, 1995

Summary: IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.

Learn more »

Drive Train, August 1, 1995

Summary: WHEN INSTALLED IN THE VEHICLES, A TIE WRAP IS USED TO GUIDE THE CRUISE CONTROL CABLE IN THE ENGINE COMPARTMENT. SOME TIE WRAPS HAVE BEEN INSTALLED WITH A LARGE LOOP OPENING IMPROPERLY GUIDING THE CABLE WHICH COULD PREVENT THE THROTTLE FROM RETURNING TO ITS FULL IDLE POSITION.

Learn more »

Body, Interior & Misc., May 5, 1995

Summary: THE JACKS SUPPLIED WITH THESE VEHICLES WERE ASSEMBLED WITH AN IMPROPERLY MACHINED SPINDLE, SO THAT A SHARP RIDGE ON THE EDGE OF SPINDLE'S THREAD WOULD HAVE REMAINED.

Learn more »
Ask a Question