2010 Toyota Sequoia Recalls
Southeast Toyota is recalling certain vehicles because the seat heater element may become damaged as a result of compression of the seat cushion. The damaged element could short causing burning of the seat cushion, increasing the risk of personal injury. Dealers will disconnect seat heaters with copper strand elements and refund the purchase price of the seat heater accessory to correct this concern.
Vehicles that have had accessories added to the seats such as seat heaters, seat covers or DVD headrests may not have the occupant sensor system of the passenger seat calibrated properly. This can affect passenger air bag operation in a crash. Dealers will test the sensitivity of the occupant detection sensors and recalibrate them as necessary free of charge to resolve the concern.
Due to a calibration error, the tire pressure monitoring system warning light may not illuminate to warn of incorrect tire pressure. Driving with the incorrect tire pressure can result in tire failure, increasing the risk of a crash. Dealers will re-initialize the tire pressure monitoring system to restore proper operation. Toyota has not provided a notification schedule at this time.
These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.
Southeast Toyota is recalling 2005–2011 models for failing to comply with federal safety standards on tire selection and rims. Affected models were sold without the proper load-carrying capacity modification labels, which may cause the driver to overload the vehicle, increasing the chance of a crash. Dealers will mail the correct labels to the customer or install the label free of charge.
Toyota is recalling 2005–2010 Avalon; 2007–2010 Camry, 2009–2010 Corolla, Corolla Matrix, and Rav4; 2010 Highlander; 2008–2010 Sequoia; and 2007–2010 Tundra models because the sliding surface of the friction lever may become smooth during operation, which can cause condensation. This may cause the accelerator pedal to become harder to depress, slower to return, or to become stuck in a partially depressed position, which can increase the risk of a crash. Dealers will install a reinforcement bar in the accelerator pedal so it will operate smoothly.