2010 Toyota RAV4 Recalls
The driver's side power window master switch may lack enough proper lubricant to protect the sliding electrical contacts of the switch. This can cause a short circuit of the switch, leading to overheating and melting of the switch. Dealers will inspect the switches and apply lubricant to them if no abnormality is found. If a problem is found, the switch circuit board will be replaced. These inspections and repairs will be performed free of charge to resolve the concern.
The windshield wiper linkage could separate at a joint that corrodes due to water intrusion. Dealers will replace the water diverter channel that keeps water away from the affected joint and install a new revised linkage with a protective cover free of charge to resolve the concern.
Southeast Toyota is recalling certain vehicles because the seat heater element may become damaged as a result of compression of the seat cushion. The damaged element could short causing burning of the seat cushion, increasing the risk of personal injury. Dealers will disconnect seat heaters with copper strand elements and refund the purchase price of the seat heater accessory to correct this concern.
If the nuts for adjusting the rear wheel alignment are improperly tightened during service, the rear tire rod may develop unwanted movement and rust, leading to thread damage and eventual failure. Failure of the rear tie rod could cause a loss of vehicle control, increasing the risk of a crash. Dealers will inspect the tie rods and replace any that have rust or corrosion on the alignment adjustment threads. All rear tie rods will then be encased in an epoxy to prevent future environmental damage.
Vehicles have a tire size/weight rating label to inform owners of the carrying capacity of their vehicle. These models are being recalled because the incorrect vehicle weight rating is shown on the information label. This could result in vehicle and tire overloading, increasing the risk of tire failure. Owners will be provided an updated vehicle weight label to correct this concern.
Vehicles that have had accessories added to the seats such as seat heaters, seat covers or DVD headrests may not have the occupant sensor system of the passenger seat calibrated properly. This can affect passenger air bag operation in a crash. Dealers will test the sensitivity of the occupant detection sensors and recalibrate them as necessary free of charge to resolve the concern.
Toyota is recalling certain model year 2006 through 2011 RAV4 and 2010 Lexus HS250h passenger vehicles. If nuts securing the rear tie rod are not tightened properly during service, unwanted movement and rust can develop leading to component failure. Failure of the rear tire rod will cause an abrupt change in the vehicle's alignment. This could lead to a loss of vehicle control, increasing the risk of a crash. As of this writing, remedy information is not available for this recall.
The accelerator pedal can become trapped under an unsecured or incompatible floor mat. This can cause the accelerator pedal to stick in the wide open position, increasing the risk of a crash. At this time, the remedy plan is still under development, but will most likely involve modification or replacement of the accelerator pedal and Toyota all-weather floor mats. No schedule of owner notification is available at this time. The Toyota recall number is 90L; the Lexus number is 90LG.
These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.
Southeast Toyota is recalling 2005–2011 models for failing to comply with federal safety standards on tire selection and rims. Affected models were sold without the proper load-carrying capacity modification labels, which may cause the driver to overload the vehicle, increasing the chance of a crash. Dealers will mail the correct labels to the customer or install the label free of charge.