2009 Toyota Camry Recalls
Southeast Toyota is recalling certain vehicles because the seat heater element may become damaged as a result of compression of the seat cushion. The damaged element could short causing burning of the seat cushion, increasing the risk of personal injury. Dealers will disconnect seat heaters with copper strand elements and refund the purchase price of the seat heater accessory to correct this concern.
Vehicles that have had accessories added to the seats such as seat heaters, seat covers or DVD headrests may not have the occupant sensor system of the passenger seat calibrated properly. This can affect passenger air bag operation in a crash. Dealers will test the sensitivity of the occupant detection sensors and recalibrate them as necessary free of charge to resolve the concern.
Toyota and General Motors are recalling certain models because the power window master switch assembly in some of these vehicles was built using a less precise process for lubricating the internal components of the switch assembly. Irregularities in this lubrication process may cause the power window master switch assemblies to malfunction and overheat. This could result in the switch melting or possibly catching fire. Dealers will inspect and repair or replace the master window switch as necessary.
During assembly, the electrical contacts of the stop lamp switch may have been contaminated with silicone grease, causing increased electrical resistance in the switch. This could result in: Illumination of warning lamps; a no start condition; the shift lever may not shift from the Park position; and/or inoperative brake lights. Inoperative brake lights would fail to warn other drivers the vehicle is slowing or stopping, increasing the risk of a crash. Dealers will replace the brake light switch to correct this concern.
These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.
Southeast Toyota is recalling 2005–2011 models for failing to comply with federal safety standards on tire selection and rims. Affected models were sold without the proper load-carrying capacity modification labels, which may cause the driver to overload the vehicle, increasing the chance of a crash. Dealers will mail the correct labels to the customer or install the label free of charge.
Toyota is recalling 2005–2010 Avalon; 2007–2010 Camry, 2009–2010 Corolla, Corolla Matrix, and Rav4; 2010 Highlander; 2008–2010 Sequoia; and 2007–2010 Tundra models because the sliding surface of the friction lever may become smooth during operation, which can cause condensation. This may cause the accelerator pedal to become harder to depress, slower to return, or to become stuck in a partially depressed position, which can increase the risk of a crash. Dealers will install a reinforcement bar in the accelerator pedal so it will operate smoothly.
Toyota is recalling 2004–2010 models for an accelerator pedal that can get stuck in the wide open position due to problems with the floor mat. This may cause high vehicle speeds that make it difficult to stop the vehicle, which can result in a crash. In order to correct the problem, dealers will replace the pedals, alter the shape of the floor, and/or replace the floor mats. Toyota will also modify software on certain models to ensure that the brake overrides the accelerator in the event that both are applied.