2005 Toyota Avalon Recalls
A seal between the master cylinder and brake booster may fail and allow fluid to leak into the brake booster. This can cause reduced braking performance. Dealers will replace the seal with a newly designed one free of charge to resolve the concern.
Southeast Toyota is recalling 2005–2011 models for failing to comply with federal safety standards on tire selection and rims. Affected models were sold without the proper load-carrying capacity modification labels, which may cause the driver to overload the vehicle, increasing the chance of a crash. Dealers will mail the correct labels to the customer or install the label free of charge.
Toyota is recalling 2005–2010 Avalon; 2007–2010 Camry, 2009–2010 Corolla, Corolla Matrix, and Rav4; 2010 Highlander; 2008–2010 Sequoia; and 2007–2010 Tundra models because the sliding surface of the friction lever may become smooth during operation, which can cause condensation. This may cause the accelerator pedal to become harder to depress, slower to return, or to become stuck in a partially depressed position, which can increase the risk of a crash. Dealers will install a reinforcement bar in the accelerator pedal so it will operate smoothly.
Toyota is recalling 2004–2010 models for an accelerator pedal that can get stuck in the wide open position due to problems with the floor mat. This may cause high vehicle speeds that make it difficult to stop the vehicle, which can result in a crash. In order to correct the problem, dealers will replace the pedals, alter the shape of the floor, and/or replace the floor mats. Toyota will also modify software on certain models to ensure that the brake overrides the accelerator in the event that both are applied.
On 133 vehicles, certain airbag inflators were assembled with an insufficient amount of the heating agents necessary for proper airbag deployment. In the event of a crash, if the airbag does not deploy as expected, the risk of injury will increase. Dealers will replace only the suspect airbags to correct this concern. The Toyota recall number is 60B. The Lexus recall number is 6LB.
The steering yoke may not have been welded to the steering shaft. In this case, the yoke may come loose from the shaft, resulting in a loss of steering control, increasing the risk of a crash. Dealers will inspect the steering yoke and shaft weld condition and replace the steering column assembly as necessary. This recall is expected to begin on May 2, 2005. The Toyota recall number is SSC 50F.