Porsche Cayenne Turbo Questions
Get answers to questions about your Porsche Cayenne Turbo at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
After high pressure washing the fuel filler cap wouldn't open and the key got stuck. I could move the key but the engine wouldn't ignite. Also the mechanic removed the air suspension control unit because he suspects it to be faulty. Please tell me what could the problem be and how to fix it. What can I do to turn the car on?
When you try and turn it over the starter clicks, everything shuts off and wont start.
without the usage of a scanner
The last major service performed was at 60,000 miles.
But since that service, oil changes have been performed, drive shaft assembly replaces, coolant pipes replaced, and both fuel pumps replaced. I recently replaced the 2 front air filters as well as the pollen cabin air filter.
I wanted to know if I should replace the spark plugs, serpentine belt, thermostat, and anything else you recommend. As I said, no major service had been done except for oil and air filter changes.
Thanks so much!!
When not driven for a while then comes off after restart.when driven regularly the light doesnt come on.
I NEED TO KNOW HOW TO CHANGE POWER SEERING PUMP
I bought the car about 1 week ago and already those 2 sensor warning came on, as well as a 'monitoring off' and front left light wanrning.
I looked underneath the car and on both sides, in the mid area at the edge, it looks like oil has leaked out of somewhere...it is dry but i can see it on both sides.
How serious are these warnings that I have mentioned above??
sometims it shift manual and ome times even if i select manual control it wont shift
Under modest driving in a 2011 Turbo S with PDK, red transmission overheat light occurred. Dealer believes problem is a faulty temperature sensor in PDK and not a mechanical problem. However, dealer says that sensor cannot be replaced.
The rear air speed control knob of the AC fell off today while trying to increase the air flow!! I tried putting it back but it i couldnt. does that mean it was broken or can it be fixed (just put back)??
I was nstalling a new front license plate cover and needed to use longer screws. The screw went through a hose located directly behind the existing hole. What hose is it? It has to be a plastic or rubber hose as it left balck on the screw, it appears to be windshield washer fluid leaking out!