Oldsmobile Cutlass Supreme QuestionsRefine by vehicle
without take the entire dash apart?
i went to go to store and car was sounding better and wasn't smoking anymore than it lost all power the engine just stalled I went to pull over than it died now won't start all the time cranks over just doesn't start when it does start I can get it to go forward but it doesn't stay running when I put it in reverse now it won't start help please what could it be
I have an oil leak coming from under the intake manifold at the right rear corner of engine, running down end of rear head, down engine and dripping to garage floor. It's been diagnosed by a mechanic as an oil pump drive shaft o ring bad. wants $450. +/- to fix. I'm a shade tree mechanic from the sixties small blocks with distributors and Holley's. Can I replace this o ring without removing the intake manifold, fuel rails and all of the electrical components? This side ways motor, fuel injection and all this computer stuff scares me! If so, please give me your pointers on how to do it!
I need to replace the ESC module but do not know where it is.
the door wont open from the inside or outside. i just replaced the door handle and pannel because the old one broke and then when i tested the locks it wouldnt unlock from the inside or outside. how do i get the door unlocked?
The longest a new fuse lasted was about 8-10 days 1994 olds Cutlass Supereme S 3.1lt.
A idle and stalls when you come to a stop . How do I fix this when I disconnect the battery's?
Turn headlights on, defrost turns off, dash lights off, while headlights on, apply brakes and headlights blink?
When I go to start my car, it doesnt crank or start, makes not one sound at all. Does that mean that my starter went bad?
it seems like my car is dead I get nothing when I turn the key
For the last few months I'am having this issue,Took it to Firestone,but they don't do that type of repair.But said it's a short and I have take it to the dealer?????What type of test will a person do to check the issue.Every other time I put a fuse in,sparks would come out,and the fuse is blown.Thanks
Every one has a OB2,but by me having a 1994 Oldsmobile Cutlass Supereme S,no one can scan for codes,needs someone to scan for ABS codes.Had it checked 2yrs ago,and seems like it had a TSB,on my car,saying that a wire is hitting the ABS sensors?
the heater hose is hot on 1 side going to the heater core, but cool on the other side. How do you get to the heater controls under the dash? Is there a valve controlling the flow of coolant going thru the heater core?
It covers the door chimes,door locks and power antane.Serveal people are saying it has a short.Any way to check.Thanks
changed head gaskets and intake gaskets set the timeing and now i was told to i have to take valve covers off and quarter turn the rockers how do i do this step by step 81 cutlass supreme v6 3.8 can hear the lifters tapping very little its running good besides the lil ticking ols help ty
Noticed like a metal grinding noise in the front of the car. First noticed when it was idling, stopped when I started driving. Then noticed it every time I started the car as well and would cease seconds after and drive just fine. Noticed it first after a roughly 60 mile drive at Interstate speeds.
is it a computer problem
I want to gain access to the cradle bolt nut without taking it all apart. I have the new nut and bolt, but I don't want the big expense of taking it to a shop. I want to do it myself.
I have a 97 Cutlass Supreme. A month ago it was fine now suddenly about a week ago it wont start. Here is a list of some issues I noticed and hope someone will read this with some helpful information.
Car wont start and it seems like the brake pedal will only go down a inch or two. It seems harder to push in. I also get a strange clicking noise when trying to turn on. Also the brake lights flash. Also when I try to start it up the mph needle jumps to 50 mph. I hope someone can help me diagnose this problem.
Just had the intake gasket replaced
had sub frame dropped,1 tierod disconnected,turned steering wheel,was a snap, . what do I do ?
I've replaced pvc line and still the code remains the same.please help me.I also have that issue with when I turn on my lights head or park my dash lights goes out.
Hey guys my when I turn the left signal on on my 94 cutlass the brake lights go out, it only happens with the left side and I already replaced the combination set itch, has anyone encountered this before?
I needed to take off a lot of overstuff to get at it. I replaced everything but now my car idles very fast. How do I adjust it? Their are tow bands that connect to a wheel that turns the car on and when I depress it, it zooms faster. How do I adjust that and turn it down?
changed brake light switch replaced bulbs still no lights every once in a while they work