Mazda MAZDASPEED6 Questions
Get answers to questions about your Mazda MAZDASPEED6 at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
I have had my 07' MS6 for 9 months and I just noticed that there is a switch inside the center armrest. I can't for the life of me figure out what it does, any ideas?
Car died and required a jump start
Codes are; (u0121) abs control module
(U0155) Cluster (IPC) control module
(U 0101) TCM Communication & ECM/ PCM(U 0100)
(P2111) Throttle actuator Control system stuck open
(P2110) Throttle actuator Control system Force limited (RPM)
ABS Pump Motor Relay/Pump Motor Circuit Malfunction needs to be addressed ABS and TCS lighrs are on solid on the dash display. Sounds like an electrical problem but not sure where to start???
AWD--front and back tires different in size. drove for 6 months until the smaller tires on the back were ripped to shreds along with a grindy, knocking noise coming from all the wheel areas. after putting the same size tires on, just a knocking noise by the wheels and big loss of power
I just filled up gas tank. Drove about 5 miles Stopped for redlight Car would not go when I stepped on the gas.
Panel lights mention above came on. Turned off ignition, turned on again. Car started then I was able to pull off road and turn off car. Restarted car check engine light came on. Able to drive home with check engine light on. Checked gas cap, tightened it. Started car drove a couple of blocks check engine light went out. A few days later it happened again. It feels like the car is shutting itself down and not allowing gas to the engine.?Again tightened gas cap three clicks. Car starts and check engine light goes off. TCS is off.
is there a diagram for the removal of the left front strut ? if so i would like to know if you would provide this info thank you
Ok i got timing chain replaced at Hall Mazda in virginia beach. Once i got it back about a week goes by and then im crozin along and i hear a knocking. took it back to them and they said it was unrelated to there work. But they said the knocking was coming from oil pan. Could this be a bad Crank bearing? They said the thrust bearing was still good. But how much would it cost to get the crank bearings replaced?
the passenger side window will not operate from the driver side but does from the paasenger side. And the auto window feature does not operate for either window (driver or passenger). All other windows work fine.