Lincoln Mark VIII QuestionsRefine by vehicle
Heater putting out cold air
trunk and turn pump switch on and off. Will run but will not restart when warm. Have to wait till cold and reset everything.
Where do i start?
Both the lincoln and mercury have the same size engine 4.6 V-8
Dash lights quit working; was intermittently, now, not at all .
Idle air control valve replaced, fuel filter replaced, plugs look great. Will die on freeway at 65 mph or in drive through at idle? No check engine light or trouble code.
The traction no long work either so I was thinking it was a warning for that.
Usually occurs when it sits in idle for a short period, or when I back out while turning hard and stop.
THE PROBLEM HAPPENS RIGHT WHEN STARTED RUNS ROUGH AND THEN OVERHEATS
car is overheating and running like crap
My anti theft system is engaged and now I cant turn key foward
plug that looks like a release valve when you drain a radiator but bigger and yellow in color and it's looks like it is mounted at the edge of oil pan or some kind of pan once i start the car oil pours out of it. looks like it might have a spring and rubber point on it. can someone help me figure out what it is or where leak might be coming from?
Tail light and brake light goes out. How do I fix it
Now it wont start It did right before now it turns over but no spark, have fuel any ideas would be appreciated
I found replacement window on ebay, and it apparently come in an entire window assembly...glass, chrome etc. How do you replace the window?
I have checked fuel button in trunk. The cam sensor. It turns over just wont start. How can you check to see if it jumped time?
I want to change the air ride suspension to regular struts and springs
I put new batt in yesterday and still dies. Drove it for a week with no prob then back to this again
I put new batt in yesterday and still dies
this started after thermostat was replaced.
I have a 1993 Mark Viii and I was told that my VCRM module needed to be replaced I ordered one from ebay because they are no longer being manufactured; is there a way to determine if the part that received is good prior to having it installed?
What exactly is the function of the VCRM and where is it located on the vehicle?