Isuzu Rodeo Questions
Get answers to questions about your Isuzu Rodeo at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
Battery light oil light and brake light came on while driving car will only start with a jump but dies 10 secs later. Battery and starter are new
Loss of power car doesn't wanna go. Pulled in my drive way put the car in park pressed the gas and my gauges don't move. I just had my battery and starter replaced.
The vehicle is leaking oil under the hood when it is running. Is this possibly something loose?
I need to no how to fix so it will start ...someone please help ...Thanks
Starts up when cold no prob. After its been driven and have to start it up any time after the initial start up it will start and shut off immediately. Have to pump the gas petal and sometimes it has to be done more then once to start again. Starter has been replaced new battery
Computer code from O'Reileys and AutoZone both read p1239.
Even after I filled the gas tank it's always reading empty and the gas light is blinking what sensor do I need to repair and how much do you think it would cost?
The car had been starting slow (4-5 seconds of cranking) for a week or so. This continued until it stalled one day while driving and would not start again. The air filter was recently cleaned.
After clutch replacement, reverse lights come on in 1st & 2nd gear, cruise control does not work and headlights only bright work.
I took my car to the shop, I was told that my computer needs reprogram by the dealership
Fan clutch knocking out as soon as I change it. Been through two already in the past two weeks. Don't know what can possibly causing it.
I replaced the original switch with a universal switch. I now need to know where the ignition2 and battery2 wires connect to. Windows and other accessories are mot working
All fuses good.
I am satisfied with my rodeo and it's really been a good car and runs great but here lately it's been getting sluggish in power and I want to put a tune-up on it but I know that it has a special type of wires for a spark plug and I want estimate on how much they cost
Just want to know
After my "anti rattle valve" went out my clutch pedal doesn't work properly and it's very hard to get into gear. Bypassed the Anti-rattle value.
It's been setting a long time ! It starts right up but then the reduced power light and check engine light comes on and it doesn't have any power ! Will some one please tell me what to check or replace?
Its a second genaration 3.5 and the check engine light and reduced power light is coming on it runs but no power ! Can some one tell me what to check or replace ?
You can take off drive about 10-20 feet and it turns off and dies was driving fine started about 4-5 says who si metimes it will drive fine
We connected a new fuel pump and the wiring instruction doesn't match. 3 of the 4 match when connection fuel is flashing and the tank shows empty
2000 isuzu Rodeo turn off after turn on for a while...how fix it.?
thank a lot
I changed my EGR valve myself but didn't set my readiness monitors then tried to go get a smog and the facility told me their machine couldn't smog my car. Makes sense now after some research. just need to do that and ill be ready.
Wiring for ignition to starter
After starting the car, I put the brake on and try to put the car into drive, but the shifter is stuck in park. It happens Everytime the car is used. Sometimes it gets unstuck when shaking the shifter around .
The fuel light is always on and the gauge is at empty. When the tank is full, the light turns off and the gauge goes up a little. After driving for a little while it goes back to empty and light flashes.
My air conditioner works fine, but I do have to change my fuse often. And I get alot of feedback in my CB radio when both are on.
All the other dash light are fine except the one behind the temp control panel.
And the gas pump is new....????