Isuzu QuestionsRefine by vehicle
Please of anyone knows what this is or any suggestions please tell me....
I'll start it and seems ok I'm park but a few seconds after putting it in drive it will die. every time doesn't make it more than ten feet. All possibilities and sugestions would be great.
The clutch pedal shaft is floating on left end of shaft so the clutch master cylinder does not engage. Looks like a guide or bushing has come apart.
I need to no how to fix so it will start ...someone please help ...Thanks
It cranks but slow and the battery (+) cable gets hot
Starts up when cold no prob. After its been driven and have to start it up any time after the initial start up it will start and shut off immediately. Have to pump the gas petal and sometimes it has to be done more then once to start again. Starter has been replaced new battery
In order to engage any exterior lights, the blackout button must be activated upon startup. The low beams still do not function. Speedometer, tachometer totally useless. All other gauges work intermittently.
It will start and when I put it on drive(D) it doesn't move .....only reverse works....
My 95 isuzu trooper starts fine but after driving for a little while bogs down and the rpms fluctuate and sometimes it stalls. When it does it takes a little work to get it to start again and when i do it doesn't happen again for a while
Computer code from O'Reileys and AutoZone both read p1239.
Even after I filled the gas tank it's always reading empty and the gas light is blinking what sensor do I need to repair and how much do you think it would cost?
The car had been starting slow (4-5 seconds of cranking) for a week or so. This continued until it stalled one day while driving and would not start again. The air filter was recently cleaned.
After clutch replacement, reverse lights come on in 1st & 2nd gear, cruise control does not work and headlights only bright work.
I took my car to the shop, I was told that my computer needs reprogram by the dealership
on my 2004 Isuzu axiom
And now the old one will not work what can I do
what would be the problem?
Fan clutch knocking out as soon as I change it. Been through two already in the past two weeks. Don't know what can possibly causing it.
Inadvertently tuned the vehicle of when backing up. The car turned off, however now it won't start and gear shift is stuck in reverse. The gear shift button will not Press.
engine revs when in neutral but while driving has no power
Radio antenna. Base into motor, plastic smooth or toothed?? Thanks
How to remove the string arm and bushings
I replaced the original switch with a universal switch. I now need to know where the ignition2 and battery2 wires connect to. Windows and other accessories are mot working
All fuses good.
I am satisfied with my rodeo and it's really been a good car and runs great but here lately it's been getting sluggish in power and I want to put a tune-up on it but I know that it has a special type of wires for a spark plug and I want estimate on how much they cost
Just want to know
After my "anti rattle valve" went out my clutch pedal doesn't work properly and it's very hard to get into gear. Bypassed the Anti-rattle value.
I need advice on re-aligning the headlight.
The left headlight points higher than the right headlight.
I turn the A/C and Heater knobs and the dash and nothing happens. The blower doesnt even turn on. Any suggestion will be helpful.