Both windows cannot be opened or shut.

Ive been working on the front end trying to replace ball joints 4 days trying to remove the ball joint have tried all I know it is a 4x4 laramie with 5.9 enging ext cab I have tried chiltons total care not a word on how to remove ball joints its an axle witth universal joints and shaft to wheel hub i rentaed a ball joint press which was the only tool O'rileys had if anyone knows of the tool or a way to remove the ball joints thanks

we did a full tune up & no codes pop up. It acts up when it wants to hot or cold it doesn't matter.. I'm thinking it's the map sensor.. id would like any help on this matter!

At 85,000 miles a frayed cable window regulator was removed and window was lifted and help in place with a piece of wood.Cable was pushed out of way when window was used.And replaced 2 weeks later,.Mean while the Van died once at stoplight,and check gages light started to pops off and on,AT times its only right side gages ,other its both,or only one gage effected,Once the window seened repaired (goes up and dn) but door wont always unlock,Check Gages light Not repaired,and within a week both headlights stop working,only on bright. Van is hard to start only when Check Gage Light is on Local Mechanic says its A Instrument Panel, its going to be one wire at a time.AutoZone clerk says its a ground wire?? What may it take to get our Van running GREAT like it has done until The window stopped working???

113k miles.

power booster is new,ascalipers and master cylinder

I was on interstate and engine just died. No hesitation, no sputtering, no warning. Engine will crank but not start. Any ideas. Any help will be appreciated.

The van is running very very sluggish, it drives at about 20 mph. The engine sounds good, not knocking or other noises.